Sources
Help build the largest human-edited directory on the web.
Submit a site - Become an editor
Wikipedia. Licensed under the GNU Free Documentation License.
Are you an expert in this subject? Join the discussion and share your knowledge at Wikipedia.org.
Special wind turbines
From Wikipedia, the free encyclopedia
| Wind turbine |
|---|
| History |
| Design |
| Manufacturers |
| Special turbines |
Contents |
Still something of a research project, the ducted rotor consists of a turbine inside a duct which flares outwards at the back. They are also referred as Diffuser-Augmented Wind Turbines (i.e. DAWT). The main advantage of the ducted rotor is that it can operate in a wide range of winds and generate a higher power per unit of rotor area. Another advantage is that the generator operates at a high rotation rate, so it doesn't require a bulky gearbox, so the mechanical portion can be smaller and lighter. A disadvantage is that (apart from the gearbox) it is more complicated than the unducted rotor and the duct is usually quite heavy, which puts an added load on the tower.
Two or more rotors may be mounted to the same driveshaft, with their combined co-rotation together turning the same generator — fresh wind is brought to each rotor by sufficient spacing between rotors combined with an offset angle alpha from the wind direction. Wake vorticity is recovered as the top of a wake hits the bottom of the next rotor. Power has been multiplied several times using co-axial, multiple rotors in testing conducted by inventor and researcher Douglas Selsam, for the California Energy Commission in 2004. The first commercially available co-axial multi-rotor turbine is the patented dual-rotor American Twin Superturbine from Selsam Innovations in California, with 2 propellers separated by 12 feet. It is the most powerful 7-foot diameter turbine available, due to this extra rotor.
Counter rotating turbines can be used to increase the rotation speed of the electrical generator. As of 2005, no large practical counter-rotating HAWTs are commercially sold. When the counter rotating turbines are on the same side of the tower, the blades in front are angled forwards slightly so as to avoid hitting the rear ones. If the turbine blades are on opposite sides of the tower, it is best that the blades at the back be smaller than the blades at the front and set to stall at a higher wind speed. This allows the generator to function at a wider wind speed range than a single-turbine generator for a given tower. To reduce sympathetic vibrations, the two turbines should turn at speeds with few common multiples, for example 7:3 speed ratio. Overall, this is a more complicated design than the single-turbine wind generator, but it taps more of the wind's energy at a wider range of wind speeds.
Appa designed and demonstrated a contra rotor wind turbine in FY 2000–2002 funded by California Energy Commission. This study showed 30 to 40% more power extraction than a comparable single rotor system. Further it was observed that the slower the rotor speed better the performance. Consequently Megawatt machines benefit most.
By:Tom Janssens
For an unusual way to induce a voltage using an aerosol of ionised water, see vaneless ion wind generator.
Wind turbines may also be used in conjunction with a solar collector to extract the energy due to air heated by the Sun and rising through a large vertical Solar updraft tower.
Main article: Airborne wind turbine
It has been suggested that wind turbines could be flown in high speed winds at high altitude taking advantage of the steadier winds at high altitudes. No such systems currently exist in the marketplace. The idea of airborne wind turbines reappears in the industry every few years, and seldom (if ever) gets off the drawing board.
One wind turbine of the type Enercon E-66 at Windpark Holtriem, Germany carries an observation deck, open for visitors.
Another Enercon E-66 wind turbine with an observation deck is in the English town of Swaffham.