Sources
Help build the largest human-edited directory on the web.
Submit a site - Become an editor
Wikipedia. Licensed under the GNU Free Documentation License.
Are you an expert in this subject? Join the discussion and share your knowledge at Wikipedia.org.
Threaded pipe
From Wikipedia, the free encyclopedia
A threaded pipe is a pipe with screw-threaded ends for assembly. Threads are generally slightly conical rather than cylindrical (like a bolt or power screw). As a result a threaded pipe joint is much like a conical plug plugging a conical hole. In addition, the threads act as a labyrinth seal. While no gasket is needed, a coating is usually applied to the threads such as teflon tape.
Especially precise threads are known as "dry fit" or "dry seal" meaning that no sealant is required for a gas-tight seal. Such threads are needed where the sealant would contaminate or react with the media inside the piping, e.g., oxygen service.
Due to the taper (cone) of the thread, when such threads are cut by a tap or a die, increasingly more material is being cut at a time as the length of the thread is increased. Beyond a pipe sizes of a fraction of an inch, it is therefore common to use powered tools when cutting such threads.
Threaded fittings are sometimes used on plastic piping. Due to the wedging effect of the tapered thread, extreme care must be used to avoid overstressing the female component of the joint. It is not uncommon for such fittings to split days, weeks, or even years after initial installation, and therefore many municipal plumbing codes restrict the use of threaded plastic pipe fittings.
- Pipe (material)
- Plumbing
- Nipple (plumbing)
- AN thread
- British standard pipe thread (BSP)
- National pipe thread (NPT)
- O-Ring Boss Seal
- RIDGID, notable manufacturer of pipe threaders
- Taps and dies
- Buttress Thread Form
This article about a mechanical engineering topic is a stub. You can help Wikipedia by expanding it.