From Wikipedia, the free encyclopedia

The power of an AM signal plotted against frequency.
Key: fc is the carrier frequency, fm is the maximum modulation frequency

In radio communications, a sideband is a band of frequencies higher than or lower than the carrier frequency, containing power as a result of the modulation process. The sidebands consist of all the Fourier components of the modulated signal except the carrier. All forms of modulation produce sidebands.

Amplitude modulation of a carrier wave normally results in two mirror-image sidebands. The signal components above the carrier frequency constitute the upper sideband (USB) and those below the carrier frequency constitute the lower sideband (LSB). In conventional AM transmission, the carrier and both sidebands are present, sometimes called double sideband amplitude modulation (DSB-AM).

In some forms of AM the carrier may be removed, producing double sideband with suppressed carrier (DSB-SC). An example is the stereophonic difference (L-R) information transmitted in FM stereo broadcasting on a 38 kHz subcarrier. The receiver locally regenerates the subcarrier by doubling a special 19 kHz pilot tone, but in other DSB-SC systems the carrier may be regenerated directly from the sidebands by a Costas loop or squaring loop. This is common in digital transmission systems such as BPSK where the signal is continually present.

Sidebands are evident in this Fourier transform of an AM broadcast.

If part of one sideband and all of the other remain, it is called vestigial sideband, used mostly with television broadcasting, which would otherwise take up an unacceptable amount of bandwidth. Transmission in which only one sideband is transmitted is called single-sideband transmission or SSB. SSB is the predominant voice mode on HF radio. Since the sidebands are mirror images, which sideband is used is a matter of convention. In amateur radio, LSB is traditionally used below 10MHz and USB is used above 10MHz.

In SSB, the carrier is suppressed, significantly reducing the electrical power (by up to 12 dB) without affecting the information in the sideband. This makes for more efficient use of transmitter power and RF bandwidth, but a beat frequency oscillator must be used at the receiver to reconstitute the carrier. Another way to look at a SSB receiver is as an RF-to-audio frequency translator: in USB mode, the dial frequency is subtracted from each radio frequency component to produce a corresponding audio component, while in LSB mode each incoming radio frequency component is subtracted from the dial frequency.

Sidebands can also interfere with adjacent channels. The part of the sideband that would overlap the neighboring channel must be suppressed by filters, before or after modulation (often both). In Broadcast band frequency modulation (FM), subcarriers above 75 kHz are limited to a small percentage of modulation and are prohibited above 99 kHz altogether to protect the ±75 kHz normal deviation and ±100 kHz channel boundaries. Ham radio and public service FM transmitters generally utilize ±5kHz deviation.

• Single-sideband modulation for more technical information about sideband modulation

• partly from Federal Standard 1037C in support of MIL-STD-188
• partly from Department of The Army Technical Manual TM 11-685 "Fundamentals of Single Sideband Communications"